The production process of "weaving" with Polyester/Nylon/PP webbing:

 

1. Using the raw material yarn, it is divided into a tube shape and divided into one yarn head,
which is put into the yarn drawing machine and pulled into the pan head.

2. The rear frame of the shuttleless machine is manually inserted into the middle wire sheet one by one.

3. The fine steel port is used by the tuner to thread into the cylinder that is connected to pull the high-speed webbing belt, arrange the flower chain, enter the baffle, and put the weft in the gear, and adjust a series of width, density, texture, thickness, etc. to weave into .

 

Can be woven into, plain weave nylon webbing, twill, pit pattern, hollow, edging, jumping point, and other webbing fine patterns.

The trademark webbing generally has a width of 2MM-200MM and a thickness of 0.15MM-1MM.

Ribbon packaging process

 

1. The surface of the tape must be flat when being beaten and reeled, which is the same as the inspection/inspection of non-woven webbing.

2. There should be no more than 3 joints per roll, the basic unit of each roll is 100 yards, and the packaging method is also customized according to the customer's requirements.

3. Do not contaminate the webbing product during the rolling and packaging process. If there is dirt on the webbing surface, it must be heated immediately before it is replaced to the polluted place.

Evaluate shipment

 

1. Check whether the webbing and belt surface are flat and free of pollution.

Second, check whether the width of the webbing product is qualified, the belt surface is flat without bending, and the interface Whether to connect with tape.

 

3. Check whether the number of webbing is correct, do the data registration, and inspect the shipment.